Siser, EasyPatterns™ Heat Transfer Vinyl in the leopard pattern.
This leopard pattenered vinyl will make a bold statement on any project you apply it to!
Application instructions for an iron ( as recommended by manufacture )
- Cut – don’t mirror
- Weed excess vinyl
- Attach the transfer / carrier sheet - High Tack Mask TTD
- Preheat for 2 to 3 seconds
- Set temperature between Cotton & Linen on your iron
- Protect your design with parchment paper or teflon sheet
- An ironing board is not recommended, you need a hard flat surface.
- Press down on your iron very firmly, do not move the iron around, pick it up and move it to the next section
- Press for 15 seconds on each section
- If you see any parts lifting a bit after you press it, replace the protector sheet and press again for another 10 seconds
- You can peel the mask, or transfer sheet hot or cold
Application Instructions for a heat press)
- Cut – don’t mirror
- Weed excess vinyl
- Attach the transfer / carrier sheet - High Tack Mask TTD
- Preheat for 2 to 3 seconds
- Protect your design with parchment paper or teflon sheet
- Preheat press to 305°F / 150°C
- Press at medium pressure for 10-15 seconds
We at Stickitvinyl include the tack mask needed with every purchase so you do not have to buy it seperately. Each piece of tack is reusable, with a 12" you will receive a 12", a 24" of camo, you will receive a 12" of tack and with a 5' or camo you will receive a 2' piece of tack. Make sure you save it and reuse with all of your patterned htv.
