Siser Easyweed Iron On- Htv - Heat Transfer Vinyl – Neon Glitter

Siser neon glitter htv will add sparkle and glitz to any project you apply it to.

Application instructions for an iron ( as recommended by manufacture )

• Mirror your image
  
• Cut
• Weed excess vinyl
•  Preheat for 2 to 3 seconds
•  Set temperature between Cotton & Linen on your iron
• Protect your design with parchment paper or teflon sheet
• An ironing board is not recommended, you need a hard flat surface.
• Press down on your iron very firmly, do not move the iron around, pick it up and move it to the next section
• Press for 15 seconds on each section
•  If you see any parts lifting a bit after you press it, replace the protector sheet and press again for another 10 seconds
• You can peel the carrier, or transfer sheet hot or cold
  

Application Instructions for a heat press

• Mirror your image
  
• Cut
• Weed excess vinyl
• Preheat for 2 to 3 seconds
• Protect your design with parchment paper or teflon sheet
• Preheat press to  320°F / 160°C
• Press at medium pressure for  15-20 seconds
• You can peel the carrier or transfer sheet warm