Siser neon glitter htv will add sparkle and glitz to any project you apply it to.
Application instructions for an iron ( as recommended by manufacture )
- Mirror your image
- Cut
- Weed excess vinyl
- Preheat for 2 to 3 seconds
- Set temperature between Cotton & Linen on your iron
- Protect your design with parchment paper or teflon sheet
- An ironing board is not recommended, you need a hard flat surface.
- Press down on your iron very firmly, do not move the iron around, pick it up and move it to the next section
- Press for 15 seconds on each section
- If you see any parts lifting a bit after you press it, replace the protector sheet and press again for another 10 seconds
- You can peel the carrier, or transfer sheet hot or cold
Application Instructions for a heat press
- Mirror your image
- Cut
- Weed excess vinyl
- Preheat for 2 to 3 seconds
- Protect your design with parchment paper or teflon sheet
- Preheat press to 320°F / 160°C
- Press at medium pressure for 15-20 seconds
- You can peel the carrier or transfer sheet warm
